Spec

Standard Specification for Steel Anti-vandal Site Accommodation

External

Wall: Manufactured from 1.6mm pressed, profiled steel to BS1449 Part 1 HR4. 2285mm in length and fully welded to top and bottom rail. Corner posts are manufactured from 3mm folded HR15 mild steel to BS1449 Part 1, 1983.

Roof: Manufactured from 1.6mm pressed, mild steel panels to BS1449 Part 1 HR4 and fully seam welded to 76mm x 38mm RSC perimeter rail.

Floor: Manufactured from 70mm x 70mm RHS bearers at 600mm centres welded to 100mm x 50mm RSC side rails. Twist lock plates at the corners, manufactured from 200mm x 10mm steel plate to accept twist locks for loading and to lock onto corner block for stacking. Fork pockets manufactured from 3mm HR4 folded steel welded to side rails at 2030mm centres. Interior floor of 18mm ply fixes to channel bearers.

Door: Manufactured from 3mm mild steel with 75mm x 50mm anti jemmy angle welded to closing edge of door and hung on a 19mm round bar full length hinge system. Welded steel door handle to exterior, door to be locked with a 5 lever insurance approved mortice lock all held in place with a rubber male and female socket.

Windows: Single glazed 900mm x 900mm sliding windows protected by heavy duty double steel shutters manufactured from 3mm mild steel plate with 10mm flat bar protection strip covering closing edge. Shutters locked from inside with heavy-duty spring loaded shoot bolts top and bottom.

Top Lift: ISO type corner blocks manufactured with 5mm RHS 10mm top plate, fully welded to corner posts.

Finish: All units are finished externally using container office paint one coat primer finish semi gloss C5000 resistant to wear, impact, salt water, mineral oil, splashes of aliphatic solvents, animal and vegetable oils,80 DFT.

Internal

Internal Roof Support Frame: Manufactured from 70mm x 70mm RHS centre beam c/w 76mm x 38mm RSC bearers at 100mm centres running along the building length.

Floor: 18mm ply covered with 2mm polyfloor, heavy-duty vinyl.

Walls & Ceiling: Manufactured from 75mm x 50mm studding at 600mm centres.

Insulation: 60mm Rockwool slabs. (Both walls and ceiling)

Wall Finish: 9mm Melamine Faced Board.

Ceiling Finish: White 4mm textured board with plastic joint strips.

Joints: Plastic covered strips.

Unit Trim: Plastic, easy clean window trim and skirting to ceiling and floor.

Electrics: To IEE 17th Edition regulations terminating at a 240v consumer unit with ELCB board.